![]() The ArduinoISP sketch is part of the Arduino software package and can be found in the examples folder.Ĭonnect the Nano to the computer by USB as usual and load the AuduinoISP sketch in to the IDE. This is done by uploading the ArduinoISP sketch. I later found this is specific to certain Arduinos only.įirst we need to turn the Arduino Nano in to a programmer. After much google research I found that I needed to keep the reset pin on the Arduino Nano high by using a capacitor between the ground and the reset pin. I assumed the Nano was the same as the Duemilanove and used the “Using an Arduino as an AVR ISP (In-System Programmer)” guide on the Arduino site. One Nano guide I did find is at Lets Make Robots This explains how to set up the Nano but it does not clearly show how to program a stand alone Atmega chip. If you google “using Arduino as a programmer” you will find most of the results are for using an UNO, very few are for the Nano. Using an Arduino as an AVR ISP (In-System Programmer) ![]() There are many guides online on how to use an Arduino to program a ATmega chip, two goods ones are: Using an Arduino Nano to program a ATmega328P chip In a previous post I showed how to make your own Arduino on a breadboard. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |